132993051.qxd 11/18/02 9:30 AM Pagina 20 (Nero/Process Black pellicola)
SymptomPossible causes
IThe programme is still running.
The door will not open
IThe door lock has not yet released.
IWater in the tub: the door cannot be opened if water is present in the
tub.
I
Spinning starts late or the machineThe electronic unbalance detection device has cut in because the
does not spinlaundry is not evenly distributed in the drum. The laundry is
redistributed by reverse rotation of the drum. This may happen several
times before the unbalance disappears and normal spinning can resume.
If, after 20 minutes, the laundry is still not evenly distributed in the
drum, the machine will not spin. In this case, redistribute the load
manually and reselect the spin programme.
The machine makes an unusualIThe machine is fitted with a type of motor which makes an unusual
noisenoise compared with other traditional motors. This new motor ensures
a softer start and more even distribution of the laundry in the drum
when spinning, as well as increased stability of the machine.
No water is visible in the drumIMachines based on modern technology operate very economically
using very little water without affecting performance.
If after the above checks, there is still a fault, call yourCustomer Care
local Bendix Service Force Centre.
For general enquiries concerning your Bendix appliance
or for further information on Bendix products, please
Service & Spare Partscontact our Customer Care Department by letter or
telephone as follows:
If you require an engineer or wish to purchase spare
parts contact your local Service Force Centre by
telephoning:Customer Care Department
Bendix
0870 5 929929
55-77 High Street
Your telephone call will be routed to the Service Centre
Slough
covering your post code area.
Berkshire
For the address of your local Service Force Centre and
further information about Service Force, please visit theSL1 1DZ
website at www.serviceforce.co.uk.Tel 08705 950950*
When you call the Service Force Centre please make*calls to this number may be recorded for training
sure you give the model and serial number of thepurposes
appliance.
This information can be found on the rating plate (see
picture) or on the guarantee card.
In-guarantee customers should ensure that the
above checks have been made as the engineer will
make a charge if the fault is not a mechanical or
electrical breakdown. Please note that proof of
purchase is required for any in-guarantee service
calls.
20 |